Some of the most popular questions asked by satellite TV owners include:

  • How to add new channels to the tuner?
  • How to tune a channel on a satellite?
  • How to find a channel on new parameters?
  • How to add a new frequency (transponder), if it is not in the satellite list?
  • ...

Since the settings menu may differ on different satellite receivers, let's consider channel search using the menu of the most popular tuner today.
Some receivers have a so-called "blind" (automatic) channel search. However, since this feature is not available in all tuners and does not always work correctly, we will not consider this search option in this article.

Manual channel search in a satellite receiver

Channel parameters on our website
Channel parameters on our website.

First, in the frequency table you need to determine the broadcasting parameters of the required channels.
At the same time, you need to make sure that your satellite system is tuned to receive from the satellites on which the desired channels are located.



Entering the main menu of the receiver
Entering the main menu of the receiver.

1. In the main menu of the receiver, find the settings (installation) of the antenna. If there is no such item, in some tuners these settings can be found in the "channel search" item. Entering this menu item, we should find the satellite settings parameters (satellite name, LNB type, DiSEqC, polarization, LNB power, signal level and quality scale, etc.). These captions may vary slightly in different receivers.

Satellite selection
Satellite selection.

2. Press "OK" on the satellite name, and select the desired one from the drop-down list.



Press the yellow button to edit frequencies
Press the yellow button to edit frequencies.

3. Press the yellow button on the remote control, as a result, we go to the frequency editing menu.


Enter the required parameters
Enter the required parameters.

4. Press the green button ("Add"), and enter the channel broadcasting parameters, according to the frequency table. If such a frequency already exists in the receiver, the tuner will display a corresponding message and go to the specified frequency.

5. After all manipulations, it remains only to press the red button of the remote control ("Transponder scan") and then - the "OK" button to search for channels according to the specified parameters.

6. Next, using the "EXIT" button on the remote control, exit all installation menus, while agreeing to save all changes made.

Usually, new scanned channels appear at the end of the general channel list.

If for any reason you could not find the channels, we recommend contacting the nearest specialized place for the installation and configuration of satellite TV systems!

And finally, a video as an example of setting up channels of the "1+1" group